Table of Contents
Advertisement
Chapter 2
This section provides general guidelines for connecting the library
to the SCSI bus. The library consists of up to three SCSI devices:
the library itself and one or two tape drives. If your library contains
one drive, it consists of two SCSI devices. If your library contains
two tape drives, it consists of three SCSI devices. For information
about SCSI cable specifications, see
46
Make certain the host computer and any peripheral devices
are turned off.
To avoid damaging the tape drives, make sure
the tape drives and library are powered off
when you connect the library to the SCSI bus.
If you are unfamiliar with connecting devices on a SCSI bus,
especially issues concerning HVD and LVD configurations,
read
Appendix
B.
Determine the SCSI bus configuration (that is, how many SCSI
buses you will connect to the library and which device you
will connect to which bus).
Make sure you have the necessary SCSI cables, jumpers, and
terminators to connect the library to the SCSI bus. (If you need
to order any of these items,
page
222.
see the inside back
cover.)
Exabyte 230D
Advertisement
Table of Contents
Need help?
Do you have a question about the 230D Library and is the answer not in the manual?
Questions and answers