Using the metal tabs (C), gently pull the charge roll HVPS PCBA and remove from the machine.
5.
Re-installation note: When replacing the charge roll HVPS PCBA, ensure that it is properly inserted into the
socket in the machine.
CMYK toner dispense auger assembly removal
Remove the operator panel front cover. See
1.
2.
Remove the top cover. See
Remove the printer front door. See
3.
4.
Remove the transfer belt cleaner. See
Remove the waste toner box.
5.
Remove the four photoconductor units.
6.
Remove the four toner supplies.
7.
Remove the printhead retract door. See
8.
9.
Remove the inner cover. See
Remove the inner plate. See
10.
"Operator panel front cover (MFP) removal" on page
"Printer top cover removal" on page
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
"Inner plate removal" on page
4-15.
4-13.
4-178.
4-145.
4-4.
4-98.
Repair information
7558-xxx
Previous
Next
Go Back
4-8.
4-41