Media Eject Clamp Clutch Removal - Lexmark X95x series Service Manual

Release the media compiler assembly (C) by pushing the front lock and the rear lock inward to release the
16.
front boss and the rear boss from the finisher.
Remove the harness from any additional parts.
17.
Remove the media compiler unit assembly through the inside of the finisher and out the front.
18.

Media eject clamp clutch removal

1. Remove the rear upper cover. See
Disconnect the connector from the sensor (media eject shaft HP) (A).
2.
Release the harness from the clamp.
3.
Disconnect the connector from the media eject clutch (B).
4.
Release the harness from the clamp.
5.
6. Release the hook securing the media eject clutch actuator (C) to the media eject clutch (B).
Front view
C
Lock
"Rear upper cover removal" on page
C
Right
Rear view
C
Lock
4-377.
7558-xxx
Repair information
4-365
Previous
Next
Go Back