Sensor (Media Eject Shaft Hp) Lag Jam - Lexmark X95x series Service Manual

381.11 Sensor (media eject shaft HP) lag jam

Step Action and questions
Check the sensor (media eject
1
shaft HP) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (media eject
shaft HP).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (media eject
2
shaft HP) for proper connection.
Is the above component
properly connected?
Check the eject shaft roll motor
3
for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Media eject motor
(forward).
5. Touch Media eject motor
(reverse).
Does the above component
operate properly?
Check the eject shaft roll motor
4
for proper connection.
Is the above component
properly connected?
Yes
Go to step 3.
Replace the sensor (media eject
shaft HP). Go to
"Sensor (media
eject shaft HP) removal" on
page 4-392.
Go to step 5.
Replace the eject shaft roll motor.
Go to
"Media eject motor
assembly removal" on
page 4-366.
7558-xxx
No
Go to step 2.
Replace the connection.
Go to step 4.
Replace the connection.
Diagnostic information
Previous
Next
Go Back
2-177