Lexmark X95x series Service Manual page 884

7558-xxx
Move the plate (A) toward the right and out in the direction shown.
6.
Remove the plate.
7.
Disconnect the connector P8308 from the finisher controller card assembly (B).
8.
Remove the screw securing the ground wire (C) to the finisher.
9.
Release the harness from the clamp.
10.
Remove the media stacker bin lift motor assembly. See
11.
procedures" on page
Disconnect the white connector and the yellow connector from the sensor (stacker bin upper limit) and the
12.
sensor (stacker bin no media).
Remove the four screws securing the stapler unit frame (D) to the finisher.
13.
Service Manual
4-410
Clamp
Rear
B
4-426.
Rear
A
C
P8308
"High capacity feeder (HCF) removal
Previous
Next
Go Back