7558-xxx
High capacity feeder (HCF) removal procedures
HCF caster removal
Remove the HCF unit from the printer.
1.
Place the machine so the HCF left cover faces down.
2.
Remove the three screws securing the HCF caster (A) to the unit.
3.
Remove the HCF caster (A).
4.
HCF controller card PCBA removal
Remove the HCF rear cover. See
1.
2.
Disconnect all connectors from the HCF controller card PCBA (A).
Remove the four screws securing the HCF controller card PCBA (A) to the unit.
3.
Service Manual
4-426
A
"HCF rear cover removal" on page
4-438.
Previous
Next
Go Back