Remove the three clamp paddles (A) by sliding them out of the media eject shaft assembly (B).
4.
Reinstallation note: Replacement is easier if you lightly moisten the rubber surface of the paddles with water.
Eject roll shaft removal
Remove the finisher front door assembly. See
1.
2.
Remove the rear upper cover. See
Move the slip clutch gear 24T (A) toward the rear as shown to disengage the stacker bin (B).
3.
Move the stacker bin down as shown to its lowest position after it is disengaged.
4.
Note: Make sure the stacker bin is at its lowest position before continuing.
Remove the upper media bin assembly. See
5.
B
A
Right
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
7558-xxx
A
Narrow
Wide
4-377.
4-419.
Repair information
4-339
Previous
Next
Go Back
4-345.