Lexmark X95x series Service Manual page 370

7558-xxx
Paper jam in the fuser
1. Open door A by lifting the release latch and lowering the door.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow
the surface to cool before touching.
2. Pull the green lever down.
3. Firmly grasp the jammed paper on each side, and then gently pull it out.
Warning: Do not touch the center of the fuser unit. Doing so will damage the fuser.
Note: Make sure all paper fragments are removed.
Push the green lever back into place.
4.
Close door A.
5.
If necessary, touch Continue from the printer control panel.
6.
Service Manual
3-34
2
1
Previous
Next
Go Back