242.06 Sensor (Tray 2 Feed Out) Late Jam - Lexmark X95x series Service Manual

242.03/242.06 Sensor (tray 2 feed out) late jam

Step Action and questions
Check the media path.
1
Is the media path free of any
media fragments?
Check the pick rollers for wear.
2
Is the above component free of
excess wear and damage?
Check the transport rollers for
3
wear.
Is the above component free of
excess wear and damage?
Check the sensor (tray 2 feed out)
4
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch PRINTER SENSOR
TESTS.
4. Touch Sensor (tray 2 feed
out).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (tray 2 feed out)
5
for proper connection.
Is the above component
properly connected?
Check the tray module upper
6
transport motor for proper
operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch PRINTER MOTOR
TESTS.
4. Touch 1TM/3TM/TTM upper
transport motor.
Does the above component
operate properly?
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 6.
Clean or replace the sensor (tray
2 feed out). Go to
"Sensor (tray
module feedout) removal" on
page 4-270.
Go to step 8.
7558-xxx
No
Remove any media or media
fragments.
Replace the pick rollers.
Go to
"Pick roller removal" on
page 4-141.
Replace the transport rollers.
Go to
"Tray module transport
rollers removal" on page 4-283.
Go to step 5.
Replace the connection.
Go to step 7.
Diagnostic information
Previous
Next
Go Back
2-115