7558-xxx
HCF transport motor removal
Remove the HCF unit from the printer.
1.
2.
Remove the HCF rear cover. See
Disconnect the connector from the HCF transport motor (A).
3.
Release the harness from the clamp.
4.
Remove the three screws securing the HCF transport motor (A) to the unit.
5.
Remove the HCF transport motor (A).
6.
HCF transport roller kit removal
Remove the HCF unit from the printer.
1.
Use needle nose pliers to remove the e-clip on the front side securing the HCF transport roller kit (A) to the
2.
unit.
Service Manual
4-446
"HCF rear cover removal" on page
A
Harness clamp
Connector
4-438.
Previous
Next
Go Back