Punch Unit Motor Assembly Removal - Lexmark X95x series Service Manual

Remove the two screws securing the punch carriage shift motor assembly (C) to the punch unit
8.
assembly (B).
Remove the punch carriage shift motor assembly (C).
9.

Punch unit motor assembly removal

Open the finisher front door assembly.
1.
2. Remove the rear upper cover. See
Remove the upper media bin assembly. See
3.
Remove the connector from the sensor (punch carriage shift HP) (A).
4.
Remove the top cover. See
5.
Remove the punch carriage assembly. See
6.
7. Disconnect the connector from the punch unit motor assembly (A).
Disconnect the connector from the sensor (punch unit motor encoder) (B).
8.
Remove the harness from the clamp.
9.
A
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Punch carriage assembly removal" on page
C
B
4-377.
4-418.
Repair information
7558-xxx
Previous
Next
Go Back
4-419.
4-372.
4-375