Unloading The System - Eaton bladeups User Manual

Preassembled System Installation

Unloading the System

The system is heavy. See Table 1 on page 18 for system weight. If unloading instructions are not
closely followed, the system can cause serious injury.
Do not tilt system more than 10° sideways from vertical.To unload the system:
NOTE
1. Remove the four shipping bolts securing the front stabilizing bracket (see Figure 7).
2. Remove the four shipping bolts securing the rear stabilizing bracket.
3. Remove the brackets.
Pallet Rear
Figure 7. Removing the Stabilizing Brackets
22 Eaton BladeUPS 12 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 7
There is a front and a rear stabilizing bracket to secure the system for shipping. The
brackets are bolted both to the pallet and the cabinet. The bolts must be removed
before unloading the system.
Bracket
CAUTION
CAUTION
Four
Shipping
Bolts