Recycling The Used Battery Or Ups; Updating The Ups Firmware - Eaton bladeups User Manual

UPS Maintenance
11. Untuck the plastic handle at the end of a battery tray. Pull the handle firmly to remove the tray. Use both
hands to support the tray as it leaves the UPS cabinet.
Repeat for each battery tray. See the following section"Recycling the Used Battery or UPS" for proper
disposal.
12. Remove the CAN Bridge Card and any optional X-Slot card from its X-Slot communication bay.
13. Remove the UPS from the rack carefully to avoid damage to other equipment or the parallel input cord.
14. If not returning the UPS for warranty, see the following section"Recycling the Used Battery or UPS" for
proper disposal.
15. Continue to "UPS Installation into an Existing Parallel System" on page 81.

Recycling the Used Battery or UPS

Contact your local recycling or hazardous waste center for information on proper disposal of the used battery
or UPS.
Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper disposal of
l
batteries is required. Refer to your local codes for disposal requirements.
Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and
l
eyes. It may be toxic.
Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead‐acid
batteries and must be disposed of properly. For more information, contact your local recycling/
reuse or hazardous waste center.
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal,
contact your local recycling/reuse or hazardous waste center.

Updating the UPS Firmware

To keep the UPS firmware updated with the latest improvements and benefits, visit www.eaton.com/
powerquality often for updates. You can download the latest firmware version. The downloadable file includes
the instructions for installing the update.
NOTE
124 Eaton BladeUPS 12 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 7
Firmware v2.0 does not operate in a parallel system with v1.xx. When adding a new
UPS to a parallel system, verify that all UPSs in the parallel system are updated to
v2.x. See Step 15 on page 91 to view the firmware version on the display panel.
WARNING
CAUTION
CAUTION