Eaton bladeups User Manual page 10

Introduction
Normal operating mode that minimizes heat generation by operating typically at >98% efficiency. The UPS
l
filters incoming AC power and provides consistent power to your equipment without draining the battery.
For utility line input that exceeds normal operating range, automatic transfer to an online, double-conversion,
l
high-frequency UPS design with pure sine wave output and power-factor correction.
ABM technology that uses advanced battery management to increase battery service life, optimize
®
l
recharge time, and provide a warning before the end of useful battery life.
Hot-swappable electronics module and batteries that simplify maintenance by allowing you to replace them
l
safely without powering down the critical load.
Emergency shutdown control through the remote emergency power-off (REPO) port.
l
One standard communication option with a DB-9 serial port.
l
Firmware that is service upgradable through the DB-9 communication port.
l
Backed by worldwide agency approvals.
l
The following accessories for the BladeUPS module are available:
Maintenance Bypass Module (MBM) to safely service the UPS without disrupting power.
l
BladeUPS 12i model only. External Battery Interconnect to connect a customer-supplied external battery to
l
the UPS for extended runtime.
EBM for extended runtime, with up to four EBMs per UPS. A 0.9m (3 ft) battery extension cable is available.
l
X-Slot
l ®
control.
The BladeUPS Bar for parallel systems, mounted in the rear of an Eaton rack, provides the required input and
output connections for the paralleled UPSs and has a single system-rated input connection. Figure 2 shows an
example of a BladeUPS parallel system.
The BladeUPS system can be installed with Eaton remote power panels and rack-mounted power distribution
systems (see Figure 2).
2 Eaton BladeUPS 12 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 7
cards with enhanced communication capabilities for network connectivity with monitoring and