PREASSEMBLED SYSTEM INSTALLATION
Pallet Front
Unloading the System
20
Eaton BladeUPS (12 kVA) User's Guide
6.
Lift the ramp off the pallet and attach it to the pallet by inserting the ramp
bracket pins in the pre-drilled holes at the rear of the pallet (see Figure 5).
Pallet Rear
Figure 5. Attaching the Ramp to the Pallet
7.
Remove the four protective cardboard corners and the bag from the system.
8.
Discard or recycle the packaging in a responsible manner, or store it for future
use.
The system is heavy. See Table 1 for system weight. If unloading instructions are not closely followed, the
system can cause serious injury.
Do not tilt system more than 10° sideways from vertical.
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Ramp
W A R N I N G
C A U T I O N