Eaton bladeups User Manual page 32

Preassembled System Installation
The system is heavy. See Table 1 on page 18 for system weights.
To prevent possible injury, do not stand in the path of the system when unloading the system from
the pallet. Unloading the system requires three people: one behind the system and one on each
side. If unloading instructions are not closely followed, the system can cause serious injury.
NOTE
5. Slowly roll the system toward the rear of the pallet. With the system supported on each side, continue
rolling the system down the center of the ramp until the system is clear of the pallet. See Figure 9.
Pallet Front
Figure 9. Unloading the System
6. Roll the system to the final installation location.
7 . Continue to the "Preassembled System Setup" section.
24 Eaton BladeUPS 12 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 7
For five and six UPS systems, batteries are shipped on a separate pallet. The
batteries are installed in the UPS module after the system is moved to the final
installation location. The weights for five and six UPS systems as they are rolled off
the pallet are:
Five UPS system: 803.8 kg (1772 lb)
l
Six UPS system: 864.6. kg (1906 lb)
l
Pallet Rear
CAUTION
CAUTION