Installing The Ramp - Eaton bladeups User Manual

Preassembled System Installation

Installing the Ramp

To install the ramp:
1. Remove the outer plastic wrap and the four protective cardboard corners from the system.
2. Discard or recycle the packaging in a responsible manner, or store it for future use.
3. Locate the ramp on the back of the cabinet. Hold the ramp in place while you cut the strap that binds it to
the system (see Figure 5).
If not held in place when the strap is cut, the ramp can fall and cause injury.
NOTE Leave this strap
installed until ready to
connect ramp.
Figure 5. Removing the Ramp
20 Eaton BladeUPS 12 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 7
Pallet Front
Wooden Mounting Guides
(2 pieces)
DO NOT REMOVE
CAUTION
Pallet Rear
Ramp