Eaton bladeups User Manual page 29

4. Lift the ramp from the back of the cabinet. Attach it to the pallet by inserting the left and right ramp pins
(tee nuts) into the pre-drilled holes at the rear of the pallet (see Figure 6).
5. Continue to the"Unloading the System" section.
Pallet Front
Figure 6. Attaching the Ramp to the Pallet
Pallet Rear
Eaton BladeUPS 12 kVA to 60 kVA (N+1) User's Guide 164201649—Rev 7
Preassembled System Installation
Tee nut
Pre-drilled hole
Ramp
21