Notes On The Installation Environment; Ii.1 Installation Space; Ii.2 Usage Environment; Ii.3 Power Supply Specifications - GRAPHTEC SignJet JS310 Series Setup Manual

Installation Space
II.1
Sufficient space must be left in front of, behind, and at both sides of the printer not only for normal
operating procedures such as the replacement of consumables, the handling of printed materials, and for
ventilation, but also for the replacement of parts in the event of a malfunction. Ensure that the space left
around the printer is as shown in the following diagram.
CAUTION: Do not install the printer in an unsteady location such as on a rickety base or on a
Usage Environment
II.2
Use the printer in the following temperature and humidity ranges.
Temperature: 20 - 28°C
Humidity: 40 - 70% (non-condensing)
•
CAUTION: If the printer is used outside the specified temperature and humidity ranges, the
Power Supply Specifications
II.3
The power supply specifications for this printer are as follows. Make sure that the power supply used
conforms to the printer specifications.
Printer control power supply: AC200-240 V, 50/60Hz
Heater power supply: AC200-240 V, 50/60Hz
Drying fan power supply: AC200-240 V, 50/60Hz
SignJet JS310 Series Set Up Guide
Approx. 3m
sloping surface. There is a risk of injury if the printer falls or topples over.
print quality may be adversely affected and the printer may malfunction.
Power Supply Precautions:
Install the printer near a power outlet that is within easy reach.
Do not connect the printer to the same power supply line that is used for
noise-generating devices such as photocopying machines, air conditioners and motors.
Connect the printer to a separate power outlet. Do not connect other devices to the
same power outlet.
II

Notes on the Installation Environment

Rear
Approx. 2m
Approx. 3m
Approx. 2m
Front
- 9 -