GRAPHTEC SignJet JS310 Series Setup Manual page 41

(2) Remove the cap from one of the outlet tubes.
Outlet tube cap
Outlet tube
(3) Position the open end of the outlet tube so that it is facing the waste liquid slot.
(4) Press the Solution button to feed the cleaning solution through the outlet tube.
Continue to hold down the Solution button until the cleaning solution flows out of the outlet tube.
Cleaning solution may be emitted from the printhead nozzles.
CAUTION: Take care not to get cleaning solution stains on your clothing.
(5) Replace the outlet tube cap that was removed in Step 2, and then remove the cap from the
second outlet tube.
(6) Press the Solution button in the same way as described in Step 4 to feed cleaning solution
through the outlet tube. Position the open end of the outlet tube so that it is facing the waste
liquid slot. Continue to hold down the Solution button until the cleaning solution flows out of the
outlet tube.
Cleaning solution may be emitted from the printhead nozzles.
CAUTION: Take care not to get cleaning solution stains on your clothing.
(7) Replace the outlet tube cap.
SignJet JS310 Series Set Up Guide
- 40 -
Waste ink slot