GRAPHTEC SignJet JS310 Series Setup Manual page 49

VI.1.5 Adjust the auto feed function.
(1) Feed the media manually.
Press down the "｜" side (Manual) of the selector switch on the media feeding system. When the
media has passed over the media sensor (or just before the media reaches the floor), return the
selector switch to the position between the "║" and "｜" markings (the OFF position).
(2) Place the empty core provided on top of the media as shown.
(3) Use a screwdriver to turn the trimmer fully to the left.
The orange LED goes out (only the green LED remains lit).
(4) Gradually return the trimmer to the right.
Stop at the position where the orange LED lights.
Gradually return the trimmer
SignJet JS310 Series Set Up Guide
LED
- 48 -