GRAPHTEC SignJet JS310 Series Setup Manual page 8

When disconnecting the power cable or interface cable, be sure to hold on to the
plug, and not pull on the cable itself.
Pulling on the cable will damage it, resulting in a fire hazard or electric shock.
Do not use or store the printer in a location exposed to direct sunlight or the direct
draft of an air conditioner or heater.
Such locations may impair the performance of the printer.
Do not use the printer in a location subject to excessive mechanical vibration or
electrical noise.
Such locations may impair the performance of the printer.
Do not use the printer in an unstable location or a location that is subject to
vibrations.
Such locations may cause the printer to tip over and cause injuries.
Do not expose the media feed sensor or take-up sensor to direct sunlight or to
direct indoor lighting.
Such actions may cause the sensors to misoperate, leading to incorrect printer operation.
Do not attempt to move the printhead carriage while the printer is turned on.
Such action may impair the performance of the printer.
Do not pull on the media or place anything on top of the media while printing is in
progress.
Such actions may impair the performance of the printer.
Do not use any sharp objects on the printer.
Such action may impair the performance of the printer.
Do not drop or shake the printheads.
Such actions will damage the printheads, or cause ink to stain your clothing.
If ink gets on your hands or any other part of your body, wash it off immediately with plenty of water and
then consult a doctor.
Do not touch the surface of the printhead nozzles.
Such action will damage the printheads, or cause ink to stain your hands or clothing.
If ink gets on your hands or any other part of your body, wash it off immediately with plenty of water and
then consult a doctor.
SignJet JS310 Series Set Up Guide
CAUTION
- 7 -