GRAPHTEC SignJet JS310 Series Setup Manual page 9

When performing an ink filling operation or moving the waste ink tanks, make sure
that you do not spill any ink on yourself.
There is a danger of ink from the tanks and tubes inserted in the tanks spattering and staining your
clothing. Take care when performing these operations.
If ink gets on your hands or any other part of your body, wash it off immediately with plenty of water and
then consult a doctor.
Do not touch the media directly after a printing operation.
If you touch media that has not dried, there is a risk of not only marking the finished print, but also of ink
staining your clothing and hands.
If ink gets on your hands or any other part of your body, wash it off immediately with plenty of water and
then consult a doctor.
Use a forklift equipment to unload the printer.
The printer weighs approximately 18ES/270 kg、 25ES/330 kg. There is a risk of lower back injury to the
person(s) attempting to lift the printer.
Take care not to become trapped under the printer and injured if it tips over while it is being
transported.
Be sure to attach the holding devices to the specified locations on the printer
when using a forklift equipment.
There is a risk of damage to the printer if force is applied at locations other than those specified.
Follow the instructions provided in section "IV Assembling the Printer".
Use the printer in environment 20°C-28°C. If temperature is low, wait for about 15-20 minutes
after turning ON the power supply (PRINTER power and HEATER power), and then confirm
printing.
SignJet JS310 Series Set Up Guide
CAUTION
- 8 -