GRAPHTEC SignJet JS310 Series Setup Manual page 32

V.1.12 Feed the cleaning solution in the sub tanks through the inlet tubes.
Position the end of each inlet tube so that it faces the waste liquid slot underneath. Press the Ink
button at the cleaning position to feed the cleaning solution through the inlet tubes.
Continue to feed the cleaning solution through the tubes until they are clean (approximately 20
seconds).
CAUTION: Take care not to get cleaning solution stains on your clothing.
Ink button
V.1.13 Empty out the cleaning solution from the ink tanks.
CAUTION: First of all, remove the waste ink tanks mounted in the printer, and then discard the
cleaning solution from the ink tanks into the waste ink tanks.
V.1.14 Feed out any cleaning solution remaining in the inlet tubes.
Press the Ink button to feed out any cleaning solution remaining in the inlet tubes. When the "No ink"
alarm sounds, from the main menu, select [Ink Status] and then press the ENTER key to continue the
cleaning solution removal operation.
Continue feeding out the cleaning solution until the "No ink" alarm sounds once again.
V.1.15 Turn off the printer power supply.
SignJet JS310 Series Set Up Guide
- 31 -