Table of Contents
Advertisement
VI.2.6
Adjust the auto take-up function.
(1) Manually feed the media until it passes over the sensor (or until just before it reaches the floor).
While holding down the FUNC key, press the ▼ key.
(2) Turn the trimmer fully to the left.
The orange LED goes out.
(3) Gradually return the trimmer to the right.
Stop at the position where the orange LED lights.
(4) Check that the media stops at the sensor after it has been automatically taken up.
Set the selector switch on the take-up unit to "║" (Auto).
(5) Check that the media is not taken up when an object is placed in front of the sensor.
Take-up roller
Place an object
here to check
the sensor.
SignJet JS310 Series Set Up Guide
- 53 -
Left-hand position
Media
Empty core
Sensor
The take-up roller does
not take up the media
even when an object is
placed in front of the
sensor.
Advertisement
Table of Contents
