GRAPHTEC SignJet JS310 Series Setup Manual page 47

(2) Press down the "｜" (Manual)side of the selector switch on the media feeding system.
(3) When the media has been fed approximately 1 m, return the selector switch to the position
between the "║" and "｜" markings (the OFF position).
VI.1.4 Load media on the platen surface.
(1) Raise the press roller control pole.
(2) Remove the screws from the flap at the rear of the printer and open the flap.
SignJet JS310 Series Set Up Guide
Remove these two screws and open the flap.
- 46 -
Right-hand position
Center position