Setting Up The Paper Receiving Tray - Riso MZ790U Instruction Manual

Setting up the Paper Receiving Tray

1
Open the Paper Receiving Tray.
Pull the Paper Receiving Tray down until it comes
to a rest.
2
Position the Receiving Tray Paper
Guides.
1)
Raise the Receiving Tray Paper Guides.
2)
Hold their lower part and slide them to fit the
paper width.
Important!:
• For thick paper such as drawing paper, position
the Receiving Tray Paper Guides a little wider
than the actual paper width.
3
Set the Paper Stopper.
1)
Raise the Paper Stopper.
2)
Slide to fit the length of the paper.
4
Adjust the Paper Arrangers.
Push out plates
Alignment of paper is affected by sizes and
strength of paper. Adjust the Paper Arrangers so
that printed paper is aligned.
Press the Paper Arranger to push the plates out,
pull up to pull them in.
For plain paper
!
Press to open all of the four Paper Arrangers.
For plain paper with images
!
lopsided on page
Press to open the two Paper Arrangers on the
more heavily printed side.
For thick paper
!
Press to open the two Paper Arrangers (right
and left) closer to the machine.
Basic Operations
Push in
33
Preparing to Print