Riso MZ790U Instruction Manual page 243

Message
Either of Masters is Made
in Ink Saving Process
Operate Dual-Color
Printing?
Enter Print Quantity Over [nn],
Programed Minimum Value
!! Exceeding Number of
Editing Areas Selected !!
Deselect Some Areas and
Redo Color Separation
!! Multi-Up is Not Available
with This Paper Size !!
Replace with Proper Paper
of Standard Size
No Master on
Print Cylinder 1
Make a New Master
No Master on
Print Cylinder 2
Make a New Master
!! Number of Copies
is set to "0"!!
Printing Operation will
Start on this Printer
Symptom
One of the masters on either Cylinder
(Drum) 1 or Cylinder (Drum) 2 was
created in "Ink Saving" mode, while the
other master is of regular printing
quality.
You are trying to print fewer copies than
previously specified on "Minimum Print
Quantity".
Too many areas are selected.
Multi-up functions cannot be used when
custom-sized paper is in the Paper Feed
Tray.
You are attempting to print, but there is
no master on the Print Cylinder (Drum).
Number of print copies is set to "0", yet
"Link-Free Volume" is set to ON when
Linked Printer is connected.
Troubleshooting
Action
Proceeding to print with existing set of
masters by simply touching [Continue]
button will result in poor color balance,
i.e., one of the colors may be too dark or
too light.
To correct this problem, touch [Cancel]
and create another set of masters in the
same mode.
Touch [Close], and specify the number
of copies higher than the number
displayed on the message.
or
You can change "Minimum Print Q'ty" on
the Admin. screen.
"p.164
Up to 50 Diagonal Corner areas and 50
Multi-Point areas may be selected.
Reduce number of selected areas.
Touch [Close].
(Alternatively, press the
key to clear.)
Load standard size paper in the Paper
Feed Tray.
Touch [Close].
Set the original and create a master.
Important!:
• Do not leave the Print Cylinder (Drum)
without a master. This dries out the
cylinder (drum) and causes damage.
You must either create a master or
perform a "Confidential" operation to
wrap a master around the Print
Cylinder (Drum).
• When printing from the machine;
Touch [Continue].
(Alternatively, press the
print.)
• When stopping the print job;
Touch [Cancel].
(Alternatively, press the
the key to clear.)
Then, enter print quantity.
"p.165
When a Message Displays
key or the
key to
key or
243