Troubleshooting For The Feed Tray; Paper Is Jammed In The Feed Tray. / The Tray Cannot Be Pulled Out Smoothly - Riso 9630 Troubleshooting Manual

Troubleshooting for the Feed Tray

This section describes precautions for using the feed tray.
Paper is jammed in the feed tray. / The
tray cannot be pulled out smoothly.
You may need to pull out the feed tray to remove
paper jammed at the far end of the feed tray.
There is a spring on the right side of the feed tray.
When pulling the tray out, hold it in the way shown
below, without touching the spring.
1 Pull the tray until it stops.
2 Lift the front side of the tray diagonally upward, and
pull out the tray.
3 Remove the jammed paper.
4 Align the white projections on both sides of the tray
with the rails, and return the tray.
Lift the front side of the tray diagonally upward, and
insert it into the rails. Next, lower the tray to the
horizontal position, and push it in.
How to Load A3 (Ledger) Paper and B4 (Legal) Paper
Install the paper guides in the proper position for the paper size that you are using. To change the position of the
paper guides, pinch both sides of the paper guide, slide it out and then slide it into the appropriate hole for the
desired paper size.
2-24
B4 (Legal)
A3 (Ledger)
When using B4 (Legal) paper
• To hold the tray with proper balance, place
your right hand on the front cover part of the
tray, and place your left hand on the left near
the back, diagonally across from your right
hand. If you hold the front part with both
hands and pull the tray, the back end may
drop due to the weight of the tray.
ComColor GD Series Troubleshooting Guide