Adjusting The Print Density [Print Density Adjustment] - Riso MZ790U Instruction Manual

Functions for Printing
Adjusting the Print Density
[Print Density Adjustment]
You can select the print density from five levels, by each cylinder (drum).
The print density may be adjusted while printing is in progress.
Important!:
• "Print Density" is not available when [Ink Saving] is selected.
"p.84
Note:
• The default print density can be set on the Admin. screen.
The factory default is set at level 3 (Standard).
"p.161
Press the
print density.
1)
Adjusting the print density used for Cylinder (Drum) 1
2)
Adjusting the print density used for Cylinder (Drum) 2
3)
Print Density Indicator
Shows the current print density.
4)
Key
Increases the print density incrementally.
5)
Key
Decreases the print density incrementally.
114

Adjusting the Print Density [Print Density Adjustment]

or key to adjust the
1 2
5
3
4