Riso MZ790U Instruction Manual page 233

T00-000:Service Call Error (in alphabetical order)
Message
!!Battery Replacement!!
Call Service
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
!!System Error!!
Turn Main Power SW OFF Then ON
If Recovery has Failed, Call Service
A00-000:Paper Jam Errors (in alphabetical order)
Message
Master Disposal Error
Pull Out Print Cylinder 1 and
Discard Master
Master Disposal Error
Pull Out Print Cylinder 2 and
Discard Master
Master Jammed in Disposal Unit
Pull Out Master Disposal Box 1 and
Remove Jammed Master
Master Jammed in Disposal Unit
Pull Out Master Disposal Box 2 and
Remove Jammed Master
Master Loading Error
Pull Out Print Cylinder 1 and
Discard Master
Master Loading Error
Pull Out Print Cylinder 2 and
Discard Master
Possible Cause
The battery is low or depleted.
A system error has occurred.
Possible Cause
The master was not properly
discarded.
The master is jammed in the
Master Disposal Unit.
The master did not properly
attach to the Print Cylinder
(Drum).
Action
Contact your dealer (or authorized service
representative) and have the battery
replaced.
Press the key or the
the error message display.
Press the key.
If the problem persists, contact your dealer
(or authorized service representative).
Shut off power, then restart.
If the problem persists, contact your dealer
(or authorized service representative).
Action
1)
Pull out the Print Cylinder (Drum) and
remove the master from the cylinder
(drum).
If a master is not wrapped around the
cylinder (drum), check the disposal
unit and remove the master.
"p.222
2)
Return the Print Cylinder (Drum) in
place.
3)
Press the key.
Pull out the Master Disposal Box and
remove the jammed master.
If the masters are difficult to remove, pull
out the cylinder (drum) and then remove.
"p.220
"p.222
If the error persists, contact your dealer (or
authorized service representative).
1)
Pull out the Print Cylinder (Drum) and
remove the master from the cylinder
(drum).
"p.222
2)
Return the Print Cylinder (Drum) in
place.
3)
Pull out the Master Making Unit and
reinstall the master.
4)
Press the key.
When a Message Displays
Troubleshooting
key to clear
233