Maximum Cp Resolution Pane - Polycom RMX 1500 Administrator's Manual

Hide thumbs Also See for RMX 1500:

Table of Contents

Chapter 2-Additional Conferencing Information

Maximum CP Resolution Pane

Depending on whether MPM or MPM+ cards are installed, the Maximum

CP Resolution of the RMX can be set to one of the following resolutions:

Limiting Maximum Resolution

Before a selection is made in this pane, the Maximum CP Resolution of the

system is determined by the MAX_CP_RESOLUTION System Flag.

The MAX_CP_RESOLUTION flag value is applied to the system during

First Time Power-on and after a system upgrade. The default value is

All subsequent changes to the Maximum CP Resolution of the system are

made by selections in this pane.

Maximum Resolution

Maximum Resolution can be limited per conference or per participant

The Maximum Conference Resolution, can be limited via the Profile - Video

Quality dialog box. For more information see "Defining Profiles" on

The Maximum Resolution can further be limited per participant endpoint

via the Participant - Properties dialog box. For more information see

"Adding a Participant to the Address Book" on page 6-4.

Resolution Configuration Pane

The user can select from 3 pre-defined Resolution Configurations or select a

manual Resolution Slider adjustment mode. The pre-defined settings can

be accepted without modification or be used as the basis for manual fine

tuning of resolution settings by the administrator.

Rmx 4000 Rmx 2000