Polycom RMX 1500 Administrator's Manual page 881

Table B-1 Alarms (Continued)
Alarm Code
SSH is enabled
Startup process failure
SWITCH not responding
System Configuration modified
Task terminated
Temperature Level - Critical
Temperature Level - Major
Terminal initiated MCU reset
The Log file system is disabled
The software contains patch(es)
The system has been configured for JITC
mode, but communication is not secured
until a TLS certificate is installed and the
MCU is set to Secured Communication.
Unit not responding
Unspecified problem
User initiated MCU reset
Polycom RMX 1500/2000/4000 Administrator's Guide
Alarm Description
Process failed:
[Process name] failed to start.
System configuration flags were modified.
Reset the MCU.
Task terminated: [Task Name].
Possible explanations:
•
Temperature has reached a critical level. Card or if
critical system element the MCU will shut down.
Possible explanations:
•
Temperature has reached a problematic level and
requires attention.
MCU reset was initiated by Terminal command [reset].
Log file system error:
The Log File System is disabled. Log files not found.
The software contains patch(es).
Although the System Flag JITC_MODE is set to YES,
the Ultra Secure Mode is not fully implemented as the
TLS certificate was not installed. Please install the TLS
certificate and set the MCU to Secured Communication
Mode to fully enable the Enhanced Security
Environment.
Possible explanations:
•
Unspecified card error.
•
Unspecified shelf error.
•
Unspecified problem.
MCU reset was initiated by a system user.
B-15