Room (Participant/Endpoint) Level - Polycom RMX 1500 Administrator's Manual

Chapter 2-Additional Conferencing Information
2-88
5
In the Telepresence Mode field, select one of the following options:
— OFF - When OFF is selected, normal conference video is sent by
the RMX.
— AUTO (Default) - The ITP features are dynamic. When AUTO is
selected and an ITP endpoint is detected, ITP features are
applied to the conference video for all participants. If all ITP
endpoints disconnect from the conference, normal conference
video is resumed for all remaining participants. ITP features are
re-applied for all participants should an ITP endpoint re-connect
to the conference.
— ON - ITP features are always applied to the conference video for
all participants regardless of whether there are ITP endpoints
connected or not.
6
In the Telepresence Layout Mode field, select the Telepresence Layout
Mode to be used in the conference. This field is used by VNOC
operators and Polycom Multi Layout Applications to retrieve
Telepresence Layout Mode information from the RMX.
The following modes can be selected (as required by the VNOC and
Polycom Multi Layout Applications):
— Manual
— Continuous presence - Room Continuous Presence (Default)
— Room Switch - Voice Activated Room Switching
7
Select the required video layout.
When Telepresence Mode is enabled, the Skin options are disabled as the
system uses a black background and the frames and speaker indication are
disabled.
8
Click OK.

Room (Participant/Endpoint) Level

Setting the participant/endpoint Telepresence Mode configures the RMX to
receive the video format of the RPX or TPX room endpoints.
To configure a participant/endpoint for Telepresence:
1
In the Address Book pane, click New Participant (
an existing Telepresence endpoint.
) or double-click