Polycom RMX 1500 Administrator's Manual page 841

6 Select the Run all Tests box and then click Run Selected Tests.
Optional. In the Diagnostics - Active Test box you can select specific tests to
run and then click Run Selected Tests.
Table 20-20 Tests Selection - Additional Test Parameters
Parameter
Loop Test
Stop On Failure
Run All Test
7 The selected tests are initialized. In the Tests Monitoring pane there is
an indication of the Connection Status of the Tests.
Connection Status
8 This process may take some time. Click Stop Running Test to end all
the diagnostic tests. The MCU completes the current test running and
then stops all remaining tests.
9 The Diagnostics Mode can be exited by pressing the yellow System
Reset icon. The RMX then resets.
Polycom RMX 1500/2000/4000 Administrator's Guide
Description
Enter the amount of times the test is to repeat itself
in succession.
Stops tests upon a failure.
Runs all tests listed in the TestActive column for the
hardware component.
20-43