Table of Contents
Advertisement
10.6.1 Configuring exit mode of partition
After entering the partition name, use the control buttons
select Type. Confirm by pressing the control button
word Select. To cancel input, press the control button
word Back.
If you confirm Type with the Select button, you see the following
graphic display:
Use the control buttons
to select the respective exit mode. For a
list of exit modes and their attributes, see the table below. Confirm your
selection by pressing the control button
cancel input, press the control button
to
under the
under the
under the word Select. To
under the word Back.
39
Function
Meaning
Timed set
The partition is activated following expiry of the
defined exit time.
Final Door Set
The partition is activated when you close a
zone with the final door property.
Instant Set
The partition is activated immediately. This exit
mode is recommended for activation via
remote control or radio cylinder.
Silent Set
As for the Timed Set exit mode, except that no
exit signal can be heard during the delay time.
As Partition 1
This option is available for partitions 2, 3 and
4. When you select this option the system
uses the same setting mode as partition 1.
Note: Do not try to make a PIR zone act as a Final Exit for a
partition. Radio PIR detectors have a "lock out" period after each
activation in order to conserve battery power. When you set (or part
set) a partition a PIR may still be in lockout, during which it cannot
send a signal to complete the setting process.
Advertisement
Table of Contents
