Table of Contents
Advertisement
10.12.3. Testing the keypad
Use the control buttons
by pressing the control button
input, press the control button
If you confirm Keypad with the Select button, you see the following
graphic display:
Press all keys on the keypad in succession. Press both dual keys
together to test. Each key should produce a response on the display.
To cancel input, press the control button
to select Keypad. Confirm your selection
under the word Select. To cancel
under the word Back.
under the word Back.
10.12.4. Walk test
Use the control buttons
by pressing the control button
input, press the control button
If you confirm Walk Test with the Select button, you see the following
graphic display: (The display shows a list of all the detectors installed on
the system.)
Now activate all detectors on the premises in succession. When a
detector is recognised, the panel issues a signal tone. It also shows
whether a tamper contact (T) and/or an alarm (A) is triggered. To
cancel input, press the control button
After you test all detectors, the display shows All zones tested.
Note that you cannot test 24 hour or fire zones.
90
to select Walk Test. Confirm your selection
under the word Select. To cancel
under the word Back.
under the word Back.
Advertisement
Table of Contents
