Table of Contents
Advertisement
10.11.2. Monitoring Interval
Use the control buttons
to select Monitoring Interval. Confirm your
selection by pressing the control button
cancel input, press the control button
If you confirm Start Monitoring Interval with the Select button, you see
the following graphic display:
Use the control buttons
to select the monitoring interval in hours.
Within this interval, every detector programmed for activity monitoring
must be triggered at least once to avoid the triggering of a social care
alarm. Select the monitoring interval so that it is within the monitoring
period defined by the monitoring start and end times.
To confirm the interval entered, select OK by pressing the control
button
under the word OK.
under the word Select. To
under the word Back.
87
10.11.3. Set Volume / Voice Connection
After the social call is triggered, a voice connection is established via
the telephone. If the panel loudspeaker volume is too low, change it
under Set Volume.
If you receive an alarm call with a speech message it may take several
seconds until you hear the message. After the message has been
played you can listen into the room.
Select DTMF for the audio connection. An alarm call needs to be
acknowledged by pressing the button 5 or 9 on the telephone
Speaking
Listening
Switching
Confirm call
Play back basic message
Confirm all calls
DTMF tone "2"
DTMF tone "1"
DTMF tone "*"
DTMF tone "5"
DTMF tone "3"
DTMF tone "9"
Advertisement
Table of Contents
