Configuring User Options - Abus SECVEST 868 Installation Instructions Manual

10.7.1. Configuring user options

Press the control button
pressing the control button
input, press the control button
After selecting User Options with Select, you see the following graphic
display:
With the control buttons
table below. To release a function for the user, press the control button
under the word Change. The option must be set to Y to be used
by the user. To end input, press the control button
Done.
to select User Options and confirm by
under the word Select. To cancel
under the word Back.
select user options according tot he
under the word
Function Meaning
Record memo Enables the user to record a voice message.
Reset after alarm Enables the user to reset the radio alarm panel
following an alarm. If you wish to allow users
to reset the system after an alarm then select
"Y". If you wish to make sure that only the
Installer can reset the system after an alarm
then select "N".
Dual key function Activates the alarm buttons on the keypad.
Zone tamper reset Enables the user to reset the radio alarm panel
with the user code following a tamper alarm. If
you wish to allow users to reset the system
after an alarm then select "Y". If you wish to
make sure that only the Installer can reset
the system after an alarm then select "N".
All omit Enables the user to lock all open zones with a
single button.
Social care button Activates the Social Care button on the
keypad.
Quick set Enables the activation of the panel without a
user code.
43