Abus SECVEST 868 Installation Instructions Manual page 68

10.10.1.10. SIA Report Restorials
Use the control buttons
selection by pressing the control button
cancel input, press the control button
If you confirm SIA Report Restorials with the Select button, you see the
following graphic display:
Use the control buttons
function (closing of an alarm zone, error clearance) is to be transmitted
to the station. If this function is disabled, only faults or alarms are
transmitted to the panel but not the restoring (OK message) of this
function. Select a function by pressing the control button
the word Select. To cancel input, press the control button
the word Back.
to select SIA Restorials. Confirm your
under the word Select. To
under the word Back.
to select whether the restoring of a
10.10.1.11. Contact ID
Use the control buttons
selection by pressing the control button
cancel input, press the control button
If you confirm Contact ID with the Select button, you see the following
graphic display:
Use the control buttons
function (closing of an alarm zone, error clearance) is to be transmitted
to the station. If only the basic function is enabled, only faults or alarms
are transmitted to the panel but not the restoring (reset) of this function.
under Select a function by pressing the control button
under Select. To cancel input, press the control button
Back.
Table lists all messages transmitted . If you select Basic, all messages are
transmitted.
If you select Basic+Restore, all messages with a number are
transmitted.
68
to select Contact ID. Confirm your
under the word Select. To
under the word Back.
to select whether the restoring of a
under the word
under the word