Table of Contents
Advertisement
10.5.4.1 Editing arming station
If you confirm EDIT arming station with Select, you see the following
graphic display:
Press the control button
confirm by pressing the control button
cancel input, press the control button
You see the following graphic display:
Use the control buttons
to select the respective function from the
table on the right and assign this function to the button of the arming
station. Confirm your selection by pressing the control button
under the word Select. To cancel input, press the control button
under the word Back.
to select the respective function and
under the word Select. To
under the word Back.
Function
Meaning
Not used
This button has no function on the
station
Full Set
After you enter the user code and press this
button, the alarm panel is fully activated.
Part Set
After you enter the user code and press this
button, a partition of the alarm panel is armed.
Unset
After you enter the user code and press this
button, the alarm panel is fully deactivated.
Output Channel
After you enter the user code and press this
button,
activated/deactivated
Pulsed)
After assigning a function to the button, program all other buttons of
the arming station in the same way. For the operation and installation
of the arming station see the product instructions.
NOTE: The entered user code decides which partition is being set or
unset. If your user code is able to set partition 1 and 3, these partitions
will be automatically set when entering the user code and pressing the
FULL SET button of the arming station. The same works for the unset.
37
arming
a
selected
output
is
(On,
Off,
Toggle,
fully
Advertisement
Table of Contents
