Table of Contents
Advertisement
The report sequence is as follows:
1. The radio alarm panel reports to the social care station if social care
reporting Call Mode is ON. The report includes a SCANCOM channel 8
to show that a two way speech path is available. The radio alarm
panel opens a two-way speech channel at the end of the report and
leaves it open until the radio alarm panel receives a DTMF '5'
command or a
timeout occurs. The social care station can send commands to the
radio alarm panel by using DTMF tones during the 2-way speech call.
The commands available are: see above
2. The radio alarm panel sends the "Home" speech message (see
"Speech Dialler") to identify the caller.
Note that you will have to use the Speech Dialler menu to record the
Home Message.
3. The radio alarm panel sends an SMS message (see SMS Reporting).
10.10.2.6. Call Acknowledge
Use the control buttons
selection by pressing the control button
cancel input, press the control button
If you confirm Call Acknowledge with the Select button, you see the
following graphic display:
Use the control buttons
acknowledged by the receiver by pressing DTMF button "5" or not. If
the function is disabled, the call is considered to have been transmitted
when the called party accepts it. Confirm your selection by pressing
the control button
under the word Back.
the control button
76
to select Call Acknowledge. Confirm your
under the word Select. To
under the word Back.
to select whether the social call is to be
under the word Select. To cancel input, press
Advertisement
Table of Contents
