Table of Contents
Advertisement
10.9.4. Answer on 1 ring
to select Answer on 1 ring. Confirm your
Use the control buttons
selection by pressing the control button
cancel input, press the control button
If you confirm Answer on 1 ring with the Select button, you see the
following graphic display:
Use the control buttons
call. To select Answer on 1 ring, press the control button
the word Select. To cancel input, press the control button
the word Back.
If this function is enabled, the call to remote maintenance is in steps.
The software calls the station, waits for two rings and then hangs up.
This activates the panel to accept the call. If the next call arrives within
10 to 90 seconds, the panel accepts the call immediately. This skips the
Rings to Answer function.
Note: When using "Answer on One Ring" set the number of rings in
"Rings to Answer" to a higher number than that used by the equipment
sharing the telephone line with the radio alarm panel. If you do not,
then the radio alarm panel will answer before the other equipment.
under the word Select. To
under the word Back.
to select when the panel accepts the
10.9.5. Access mode
Use the control buttons
selection by pressing the control button
cancel input, press the control button
If you confirm Access Mode with the Select button, you see the following
graphic display:
Use the control buttons
Table 17) for remote maintenance by remote communication. To
under
select a number of rings, press the control button
under
Select. To cancel input, press the control button
Back.
56
to select Access Mode. Confirm your
under the word Select. To
under the word Back.
to select an access mode function (see
under the word
under the word
Advertisement
Table of Contents
