Figure 5: Level Adjusting End Caps - Stairmaster FreeRunner 5400 ESS Owner's Manual

INSTALLATION INSTRUCTIONS
B. Level the Machine:
1. Make sure the machine is level before you use it for the first time. The
rubber end caps (see Figure 5) are designed to compensate for uneven
floors . Each face of the caps is a different thickness. Twist the caps to
stabilize the machine.
ROTATE TO ADJUST

Figure 5: Level Adjusting End Caps

C. Connect the Power Supply:
1. Remove the external power supply from the shipping box. Connect the DC
power cable to the DC power connector located on the lower left side (see
Figure 6).
TO REDUCE THE RISK OF ELECTRICAL SHOCK AND FIRE AND TO
PREVENT SEVERE DAMAGE TO THE MACHINE, USE ONLY THE POWER SUPPLY
APPROVED FOR USE WITH THIS EQUIPMENT. IN ADDITION, YOUR MACHINE
MUST BE PROPERLY GROUNDED.
2. Place the power supply on the floor near an AC wall outlet. To reduce the
hazard of electrical shock, place the power supply in a location away from
the mach ine and away from exposure to perspiration. You should not place
your power supply on a carpet because it may overheat.
Page 8
LEVEL ADJUSTING
END CAP
(PN 24329)
WARNING