Drive Sprockets; Upper Heel Link Idler Sprockets - Stairmaster FreeRunner 5400 ESS Owner's Manual

7. Reassemble the mach ine in reverse
heel link pivot assembly so that it is parallel with

Drive Sprockets

1. Remove the side cover.
2. Remove the lower POly-V belt, and remove the snap
lower POly-V pu lley from the drive shaft.
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE PROTECTION WHEN REMOVING
3. Remove the spring from the
spring cha in from the sprocket.
4. Remove the snap ring and washers from the
TO REDUCE THE RISK OF EYE
5. Rotate the sprocket off the drive
6. Install the right sprocket with the teeth facing the
left sprocket with the teeth facing the side
7. Reinstall the side cover.

Upper Heel Link Idler Sprockets

1. Remove the appropriate peda
2. Remove the power control board (left side
PARTS REMOVAL AND REPLACEMENT
order, and adjust the top edge
the floor (see
ring,
WARNING
SNAP RINGS.
spring hanger, and disengage
drive shaft (right side
WARNING
INJURY, WEAR EYE PROTECTION WHEN REMOVING
SNAP RINGS.
shaft.
mounting block and
cover (see Figure 23)
l, side cover, and safety panel.
only) .
of the
Figure 29).
washers, and
the pedal arm
only) .
the
.
Page 65