Table of Contents
Advertisement
8.
Check the pedal shafts and bushings by removing the pedal (see Figure 26).
Inspect the shafts and bushings for signs of wear and corrosion. Clean
corrosion off the pedal shafts with fine steel wool and replace any worn
bushings before reassembling. DO NOT SAND THE PEDAL SHAFT.
9.
Reinstall all parts, ensuring proper tension of the POly-V pulley belts and
that
the
top
edge of the heel link pivot assembly is parallel with the floor
(see
Figure 29). Lubricate all chain assemblies.
10.
Contact our Customer Service Department at (800) 331-3578 for assistance.
International
customers should contact their local
TROUBLESHOOTING
distributors.
Page 37
Advertisement
Table of Contents
Troubleshooting
