Heel Link; Heel Link Pivot Assembly - Stairmaster FreeRunner 5400 ESS Owner's Manual

HEEL LINK

1. Remove the pedal (see Figure
2. Remove the snap ring from the heel
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE PROTECTION WHEN REMOVING
3. Separate the heel link from the pivot assembly.
4. Install the new heel link and reinstall the pedal. Remember to lubricate the
pedal shaft with mineral oil before installing the pedal.

Heel Link Pivot Assembly

1. Remove the pedal.
2. Remove the safety panel and side
3. Remove the heel link pillow block bearing and unhook the extension
4. Remove thejam nut and washer from the pivot assembly shaft (see Figure
25).
5. Remove the heel link sprocket, with the chain attached, from the pivot
assembly shaft.
6. Pull the pivot assembly out from the heel link bearing
7. Install the new pivot assembly,
inserted into the key way. Reassemble the machine in reverse order.
8. Adjust the top edge of the heel link pivot assembly so that it is horizontal
with the floor (see Figure 29)
PARTS REMOVAL AND REPLACEMENT
26).
link pivot assembly.
WARNING
SNAP RINGS.
cover.
block.
and ensure that the pivot shaft key is fully
.
spring.
Page 57