Stairmaster FreeRunner 5400 ESS Owner's Manual page 48

3. Firmly press each button. If the LED corresponding to the key you pushed
does not light up, the keypad
4. Press [STOP] to end the test.
Software Revision Level Test
This test will show you the
1. Press [4] to start the test.
2. The software revision number will
console automatically returns to the DIAGNOSTIC
Brake Test
Use this test to verify that the brake limit switches are triggered
Adjust the limit switches if these tests fail. For replacement procedures refer to
the cable section of "Parts Removal and Replacement.
1. Remove the left side cover.
2. From the DIAGNOSTIC mode,
scroll the message, "brake
3. Press [INCREASE] to turn
off, and that the "Motor Direction" LED
4. Press [DECREASE] to turn the brake off. Verify that the
off, and that the "Motor Direction
[STOP] to end the test.
5. From the DIAGNOSTIC mode,
Verify that the brake cam
and that the cam is not hitting the mechanical stops (see Figure 31).
6. Press [STOP] to end the test. Reinstall the side cover.
TROUBLESHOOTING
is bad and the console should be replaced
revision number of the console software.
be scrolled across the
mode.
press [7] to start the test. The console
on," or "brake off," accordingly.
the brake on. Verify that the "Motor
is on (see Figure 33)
" LED is off (see Figure 33)
press [6] to cycle the motor continuously.
is triggering the upper and lower limit switches,
.
text bar. The
correctly.
will
On" LED is
.
"Motor On" LED is
. Press
Page 35