Table of Contents
Advertisement
PARTS REMOVAL AND REPLACEMENT
CABLES
Alternator Cable
1.
Remove the left side cover.
2.
Unplug the alternator cable from the power control
3.
Remove the
wiring
from the alternator, noting the origin and color of the
wires
removed from each terminal.
4.
Install the new cable and verify the wiring connections (see Figure 36).
5.
Reinstall the
cover.
Contact Heart Rate Cable
1.
Remove the console knobs, and gently lift the console
2.
Disconnect all cables from the back of the console and remove the console
3.
Lift each sensor grip up from the console handlebar and disconnect the two
wires from each pair of sensors.
4.
Pull the contact heart rate cable out from the middle hole
handlebar.
5.
Thread the left side of the new cable through the left side of the console
handlebar, and connect the wires to the sensors.
Note: Do not reverse the left and right heart rate cables during
installation. Pins 1 and 3 are used in the left cable, and pins 1 and 2 are
used in the right cable.
6.
Thread the right side of the new cable through the right side of the console
handlebar, and connect the wires to the sensors.
Page 44
board.
up.
in
the console
Advertisement
Table of Contents
Troubleshooting
