Mounting Blocks; Pedal Assembly - Stairmaster FreeRunner 5400 ESS Owner's Manual

PARTS REMOVAL AND REPLACEMENT

MOUNTING BLOCKS

1. Remove the covers. Have an assistant help you prop the front of the
machine up with wooden
mounting screws !
2. Remove the front and rear drive chain assemblies.
3. Remove the step chains and heel link chains.
4. Remove the drive shaft assembly.
5. Remove the mounting block screws and washers from the bottom of the
machine, and remove the mounting
7. Remove the heel link idler
the mounting blocks.
8. Attach the drive chain idler sprockets and the heel link idler sprockets to the
new mounting blocks.
9. Install the new mounting blocks. Do not reverse the right and left mounting
blocks.
10. Reassemble the machine in reverse order, and adjust the top edge of the
heel link pivot assembly so it

PEDAL ASSEMBLY

1. Disengage the brake and push the pedals
2. Remove the six cover fasteners from the pedal cover, and lift the cover, with
the foot strap, off the pedal support (see Figure
3. Remove the foot strap mounting fasteners from under the pedal cover.
4. Remove the four mounting screws from the rear bearing block of the pedal
support.
blocks. Be careful not to block access to the
blocks.
sprockets and the drive chain idler sprockets from
is parallel with the floor (see Figure 29).
apart.
27).
Page 59